cyryl писал(а):
I build the interface like on this pdf
http://www.plmsdevelopments.com/images_ ... f_rev4.pdf but the output line on connector in my car are different place and thats why I'm writing this post.
Generally I wanted to write a PC application to communicate with car via consult protocol (plmsdevelopments.com/images_ms/Consult_Protocol_&_Commands_Issue_6.pdf)
In future I planned to write embedded system for it (some system based on ARM controller) but as far as I can't connect it my ECM a can't do it.
1. You tried to verify this yours device in other Car(s)?
cyryl писал(а):
I have cable connected only to pin 1, 5, 8, 9, 10, 11, 13, 14.
2. As I understand (by yours photo) Primera a'96 use pins #1 (maybe Rx-?), #2 (Tx-?), #7, #8 and #9.
You did try to connect up to them (with respect to designation)?
Maybe this diesel Primera use other addresses of registers and blocks ...
3. You did try talk to Mr. Isaac Zia (Author
http://techdiag.co.uk/obdscantech/ ) ?
BR,