"Погадаем" говорите, давайте
Данные Freeze Frame Data этих DTC и логи параметров систем, в которых они считаны?
"Впал в стопор" - кто и как именно?
Коды неисправности и параметры (лог) системы когда "
его очень колбасило"?
Номер нынешней версии ПО (CALIBRATION ID)?
DTC B2419 = BEAN Communication Malfunction (LIGHTING SYSTEM)
The AFS ECU receives signals regarding the lighting condition of the headlight, shift position of the transmission, engine condition from the generator and vehicle speed from the combination meter using multiplex communication.
When the DTC (B2419) is output, the other BEAN communication DTCs are also output at the same time
DTC Detection Condition:
• Malfunction in multiplex communication system
• Open or short in multiplex communication system circuit.
Use the intelligent tester (or Techstream*) to check if the Multiplex Communication System (MPX) is functioning normally
* И могу повторить этот давний совет
viewtopic.php?f=14&t=1072&p=8775#p8774 ...
p.s.B2286 = Runnable Signal Malfunction (SMART ACCESS SYSTEM WITH PUSH-BUTTON START)
This DTC is output when :
1) the brake signal circuit between the power source control ECU and the stop light switch is malfunctioning; and
2) the cable and BEAN information are inconsistent.
HINT:
When the power source control ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.DTC Detection Condition: Serial communication signals and multiplex communication signals in the circuit between the power source control ECU and engine control ECU are inconsistent.
Trouble Area:
• Multiplex communication system
• CAN communication system
• ECM
• Power source control ECU
• Wire harness or connector